Forums Home

« Back

Feature Requests

Carlos Zaffari's picture

Points

33

Carlos Zaffarijoined December 20, 2016

posted Saturday, January 14, 2017 | 6:20 am PST

Hello,

It will be god to have a place to communicate bugs.

By the way I found a bug in my simulation.

I created a very simple design with a 5 volts voltage source and two resistors making a voltage divider.  When the resistor values are 1M and 330K the displayed voltage was wrong. When the resistor value are 1000K and 330K the displayed voltage value is OK .

Best regards,

Carlos

Rate this post

Comments

M vs. Meg

Thanks for posting this issue, Carlos. The reason "1M" didn't simulate correctly is because it was interpreted as 1 milliohm, not 1 Megaohm. If you try "1Meg" instead of "1M", it should simulate correctly.